Mercedes-Benz G63 AMG

An attempt to replicate the original G Wagon from Mercedes, based on my 6x6 G63 AMG variant.

How to build the rover

I recommend to print it instead of welding manually each block of this vehicle.
Once printed, apply immediately the following procedure:

1. Below the chassis, remove one of both hinge heads.
2. Place one another on the remaining hinge head.
3. Attach the headless hinge.

If the procedure is not respected, the connector will detach from the main body when triggering the "TB Connector" timer block, instead of being retracted inside the chassis.

Features

- Configurable wheels settings from toolbars: height offset (low), power (high), strength (soft), friction (high)
- 1x projector to repair damaged areas.
- 4x seats
- 1x empty programmable block
- 2x gyroscopes
- 4x parachutes
- 1x rear camera
- Twin v4 H² engine

Information

PCU: 2.9k
Blocks: 481

Speed: 240 km/h
Main power supply: 2x hydrogen engine + 6x hydrogen tanks
Rescue power supply: 1x battery
Recharge: 1x connector, 2x small reactors

I wish you all a happy new year!

          ^           ^          ^          ^          ^         
         [1]         [5]        [9]        [13]       [17]         
LS+A      LS+B
         [4]         [8]        [12]       [16]       [20]         
          V           V          V          V          V         

Originally published on steam workshop: https://steamcommunity.com/sharedfiles/filedetails/?id=2702199666